Tyrant CNC teases the Intellifire trigger for the SIG P365

ByEditor

Guns and Tactics is at the annual NRA Convention 2023 edition from Indianapolis, Indiana. Check out all our coverage from the floor.

Watch it all from NRA 2023.

Want more posts like this one? Subscribe to Guns & Tactics to receive email updates and special offers direct to your inbox!

Social Links:

– The views and opinions expressed on this web site are solely those of the original authors and contributors. These views and opinions do not necessarily represent those of Guns & Tactics, the administrative staff, and/or any/all contributors to this site.

– Affiliate Disclaimer: Guns and Tactics is reader/viewer supported. This post may contain affiliate links and we may earn a small commission when you click on the links at no additional cost to you. As an Amazon Affiliate I earn from qualifying purchases.

[mc4wp_form id=”30235″]

Editor
Written by Editor

Editor

Guns & Tactics is an online media outlet that focuses on the firearms community, not just firearms and gear but also quality training, technical break downs and enlightening presentations.

Sign-up to UN12 Newsletter

Newsletter Subscription Form (Email Address Only)

Privacy Notice: By signing up to the newsletter you consent to our Terms of Use and our Privacy Policy . This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Similar Posts

Hammerhead Rifle Tool II: Handy Tool for your Toolbox

The Hammerhead Rifle Tool II (HHRT V II) is a handy little no-nonsense armorer’s tool that has become a welcome addition to my toolbox. I see ARs as tools for use, not for lining a safe. Although I like to build an aesthetically pleasing carbine, I am more concerned with the functionality and reliability of any carbine that I build. It’s going to get used, get dirty, and show some “character” in the long run.